|
||||||
|
Client PC will start the Automatic Repair on boot, fails and then restarts and does it again. From this link describes how to stop the automatic repair. Basically you need to a elevated command prompt and type the following: bcdedit /set {default} recoveryenabled No Reboot and then it might give you […] Client upgraded PCs to new with Windows 10. Issue is the ones with an HP LaserJet 401 printers the driver installed fine and it would print fine. After shutdown and with printer down and then start it up again it would not print. It would also load the built in USB driver disk […] One of the things that Microsoft did with Windows 10 (and Windows 8) was remove the option to switch to Safe Mode or Repair by pressing the F8 Key on boot. Why they did this was to improve boot time. I think it was a wrong move. Just to save a few seconds […] |
|||||
|
Copyright © 2025 Steve the IT Tech Guy - All Rights Reserved Powered by WordPress & Atahualpa |
||||||
Recent Comments